
High-Speed, Wide-Input,
Single-Phase MOSFET Driver
ABSOLUTE MAXIMUM RATINGS
V CC to GND ..............................................................-0.3V to +7V
PWM, EN, DL, DLY to GND ........................-0.3V to (V CC + 0.3V)
BST to PGND..........................................................-0.3V to +35V
LX to PGND ...............................................................-1V to +28V
DH to PGND ..............................................-0.3V to (V BST + 0.3V)
DH, BST to LX...........................................................-0.3V to +7V
DH and DL Continuous Current......................................±200mA
Continuous Power Dissipation (T A = +70°C)
10-Pin μMAX (derate 5.6mW/°C above +70°C) ........444.4mW
10-Pin TDFN (derate 24.4mW/°C above +70°C) .......1951mW
Operating Temperature Range ...........................-40°C to +85°C
Junction Temperature ......................................................+150°C
Storage Temperature Range .............................-65°C to +150°C
Lead Temperature (soldering, 10s) .................................+300°C
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
ELECTRICAL CHARACTERISTICS
(V CC = V BST = V DLY = V EN = 5V, V GND = V PGND = V LX = 0V; T A = -40°C to +85°C, unless otherwise noted. Typical values are at T A =
+25°C.) (Note 1)
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
UNDERVOLTAGE PROTECTION
V CC Supply Voltage Range
4.5
6.5
V
Undervoltage Lockout (UVLO)
Shutdown Supply Current
Idle Supply Current (I CC )
Control Supply Current (I GND )
Driver Supply Current (I PGND )
0.25V hysteresis
V EN = 0V, V CC = 6.5V
No switching
No switching
Switching
No switching, I CC
No switching, I BST
Switching, I BST + I CC
V CC rising
V CC falling
PWM = GND or V CC ,
T A = +25°C
PWM = GND or V CC ,
T A = +85°C
V CC = 6.5V, PWM = GND,
R DLY = 47k ?
PWM = GND
PWM = V CC
f PWM = 250kHz,
50% duty cycle
PWM = GND
PWM = V CC
PWM = GND
PWM = V CC
250kHz
3.25
3.0
0.04
0.1
330
25
2
1.8
0.1
1.2
0.1
1.2
2
3.80
3.5
1
500
50
3
3
10
2
10
2
4
V
μA
μA
μA
mA
mA
μA
mA
μA
mA
DRIVER SPECIFICATIONS (See the Timing Diagram )
PWM = GND,
V BST = 4.5V
1.3
2.4
DH Driver Resistance
sourcing current
PWM = V CC ,
V BST = 5V
V BST = 4.5V
1.2
0.7
1.1
?
sinking current
V BST = 5V
0.6
2
_______________________________________________________________________________________